CCNA ICND2 Lab14 - Frame Relay

Lab Tips:

The Frame-Relay protocol is a data-link layer packet switching protocol that is used in the line. The line only checks errors. These errors are solved by the upper-layer protocols such as TCP. The frame-relay is connection-oriented and provided by VC. VC is full-duplex and provides full connections at a low cost.

Topology:

Lab Requirements:

1. A Cisco router is used as a frame-relay switch.

2. Meet the frame-relay lab requirements. The figure above gives the specific parameters.

Lab Process:

RouterFR(config)#frame-relay switching           / Enable the frame-relay function of the router

RouterFR(config)#interface serial 1/1

RouterFR(config-if)#encapsulation frame-relay             / Encapsulate Frame-Relay protocol

RouterFR(config-if)#frame-relay intf-type dce Set s1/1 as the dce end

RouterFR(config-if)#clock rate 64000

RouterFR(config-if)#frame-relay route 100 interface s1/2 200             / Source DLCI 100 passes s1/2 to reach destination DLCI 200

RouterFR(config-if)#no shutdown

RouterFR(config-if)#exit

RouterFR(config)#interface serial 1/2

RouterFR(config-if)#encapsulation serial 1

RouterFR(config-if)# frame-relay intf-type dce

RouterFR(config-if)#clock rate 64000

RouterFR(config-if)#frame-relay route 200 interface serial 1 100

RouterFR(config-if)#no shutdown

P4S-R1(config-if)# interface serial 1/1

P4S-R1(config-if)#ip address 192.168.1.1 255.255.255.0

P4S-R1(config-if)#encapsulation frame-relay

P4S-R1(config-if)#no shutdown

P4S-R2(config-if)# interface serial 1/1

P4S-R2(config-if)#ip address 192.168.1.2 255.255.255.0

P4S-R2(config-if)# encapsulation frame-relay

P4S-R2(config-if)# no shutdown