CCNA ICND2 Lab2 - Set Router Port Address/Label and Save Settings

Lab Topology:

Lab Requirements:

1. On the router port, set the IP address to 202.119.249.219 and mask to 255.255.255.0.

2. Set the router prompt message to welcome to router CCNAlab.

3 Set the router port prompt message to this is a serial port

4. Save the settings.

Lab Process:

Router>enable

Router#configure terminal

Router(config)#interface fastethernet 0/0

Router(config-if)#ip address 202.119.249.219 255.255.255.0     / set the IP address of fast Ethernet port fa0/0

Router(config-if)#no shutdown     / activate the interface

Router(config-if)#exit

Router(config)#banner motd @   / set the login greeting

Enter TEXT message. End with the character '@'.

welcome to router CCNAlab @

Router(config)#interface serial 0

Router(config-if)#description this is a serial port    / set port description

Router(config-if)#end

Router#copy running-config startup-config     / save the settings

Destination filename [startup-config]?

Building configuration...

[OK]